Eglucent

Yes, Eglucent Rapid (3ml Each) Solution for Injection is considered safe to use in pregnancy if prescribed by your doctor. Consult your doctor if you become pregnant or are planning to become pregnant while using Eglucent Rapid (3ml Each) Solution for Injection. Your dosage may need to be adjusted by your doctor and you may also require more frequent blood glucose monitoring.

The most common side effect of Eglucent Rapid (3ml Each) Solution for Injection is hypoglycemia. Symptoms of hypoglycemia include nausea, headache, irritability, hunger, sweating, dizziness, fast heart rate and feeling anxious or shaky. It happens more often if you miss or delay your food, drink alcohol, over-exercise or take other antidiabetic medicine along with it. Hence, regular monitoring of the blood sugar level is important. Always carry some sugary candies, glucose/glucon-D or fruit juice with you.

If you are a type 1 diabetes patient, then yes, you have to take Eglucent Rapid (3ml Each) Solution for Injection for the rest of your life. This is because your body is unable to produce sufficient insulin and therefore you would need Eglucent Rapid (3ml Each) Solution for Injection as an external source of insulin. However, if you are a type 2 diabetes patient, in some cases your doctor may ask you to stop Eglucent Rapid (3ml Each) Solution for Injection if you are able to manage your diabetes with proper exercise, diet and oral medicines.

Unopened cartridges and unused pre-filled pens of Eglucent Rapid (3ml Each) Solution for Injection must be stored in a refrigerator where the temperature is between 2°C to 8°C. Do not freeze and do not use Eglucent Rapid (3ml Each) Solution for Injection if it has been frozen. When the cartridge has been inserted into the injection pen, it should not be refrigerated and should be kept at room temperature, below 86°F (30°C) and must be used within 28 days or be discarded, even if they still contain Eglucent Rapid (3ml Each) Solution for Injection.

Yes, hypoglycemia is the most common side effect of Eglucent Rapid (3ml Each) Solution for Injection is hypoglycemia. It happens more often if you miss or delay your food, drink alcohol, over-exercise or take other antidiabetic medicine along with it. So, don’t skip meals and be consistent in the timing and amount of your meals. Take some snacks as per your requirement if you over exercise. Always carry some glucose tablets, honey or fruit juice with you. Regular monitoring of the blood sugar level is important. Take all your medicines prescribed by the doctor on time and consult your doctor if you notice any fluctuations in your blood sugar levels.

Wash your hands before injecting. Choose a site for injection and clean the skin as instructed. Remove the pen cap and wipe the same site is not used more than once in a month. Remove the paper tab from the pen needle and then screw the needle tightly on top of the pen. Select the prescribed dose and then place the pen at around 90 degrees at the chosen injection site and press the dose button. Hold the pen in the same position for around 10 seconds to make sure the entire insulin is injected into the skin. Remove the needle, unscrew it and discard it. Place the cap on the pen and store it.

No, Eglucent Rapid (3ml Each) Solution for Injection solution must not be mixed with any other insulin preparation. Also, do not mix insulin in vials with insulin in cartridges.

Eglucent Rapid (3ml Each) Solution for Injection is injected under the skin (subcutaneously). Your doctor will show you the area of your skin where you should inject it. Try not to inject on the same spot every time. Rotate between the typical injection sites, such as abdomen, buttocks, upper legs, or upper arms. Never inject Eglucent Rapid (3ml Each) Solution for Injection into a muscle or vein. Move to a new injection site every week or two. Inject in the same area of the body, making sure to move around within that area with each injection. Then move to another area of your body and repeat the process. Use the same area for at least a week to avoid extreme blood sugar variations.

Yes, you need to prime your pen before injecting. Priming means removing the air from the needle and insulin. Dial 2 units and keep the pen vertical, facing towards the ceiling. Now, press the dose button till a drop appears on the tip of the needle. If you are using the pen for the first time, you might have to repeat the process till a drop is visible.